Thingiverse
Strawberry plant support
von LaurentN
83
Downloads
48
Likes
0
Makes
Support strawberry plants so that the fruit does not touch the ground and rot.
Printable in one or two parts (if the plants are already large)
Then print the feet separately to choose the height between 100mm and 70mm
-----------------------------------------------
Support plants de fraisiers pour que les fruits ne touchent pas le sol et ne pourrissent pas.
Imprimable en une partie ou deux parties (si les plants sont déjà grands)
Puis impression des pieds séparément pour choisir la hauteur entre 100mm et 70mm
Printable in one or two parts (if the plants are already large)
Then print the feet separately to choose the height between 100mm and 70mm
-----------------------------------------------
Support plants de fraisiers pour que les fruits ne touchent pas le sol et ne pourrissent pas.
Imprimable en une partie ou deux parties (si les plants sont déjà grands)
Puis impression des pieds séparément pour choisir la hauteur entre 100mm et 70mm
LaurentN veröffentlicht auch auf
44 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!