Strawberry Planter (for Vase Mode)

This is a strawberry planter pot with multi-level tiered openings, 10 in total counting the top. Designed specifically for printing in Vase or Spiralized mode. To print this, you must enable Vase Mode or Spiralize Outer Contour mode. To increase strength, I recommend setting Outer Wall Width to .8 Also, at least in Cura, to ensure the drainage hole prints right, while using vase mode, set the bottom layers' thickness to 1mm, so 5 layers at 0.2mm layer height. The _fix version fixes a bit of a misalignment in the smoothness of the sides. Wasn't a huge deal, but my OCD made me fix it. heh