Thingiverse
Strawberry Support
por markzieg
1
Descargas
4
Likes
0
Makes
This gadget, a strawberry riser, keeps your strawberries off the ground and away from ants and other bugs!
The "embedded" version (pictured) is a two part print. First print the text in an accent color and then swap colors. Slice the embedded version with the text face down, and add a print pause at the final layer before the print would bridge over. When the print pauses, pop the text in, continue the print. The letters will be welded in place. Its advised to print the text about 2% smaller than the riser so that it goes in without much effort.
The "embossed" version is a single print with the text recessed into the riser.
The "blank" version is for you to modify with your own text. This can be done in tinkercad or other CAD of your choice.
The "basic" version uses the least filament and prints the fastest. You can stretch or shrink this version in your slicer to customize.
The "embedded" version (pictured) is a two part print. First print the text in an accent color and then swap colors. Slice the embedded version with the text face down, and add a print pause at the final layer before the print would bridge over. When the print pauses, pop the text in, continue the print. The letters will be welded in place. Its advised to print the text about 2% smaller than the riser so that it goes in without much effort.
The "embossed" version is a single print with the text recessed into the riser.
The "blank" version is for you to modify with your own text. This can be done in tinkercad or other CAD of your choice.
The "basic" version uses the least filament and prints the fastest. You can stretch or shrink this version in your slicer to customize.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
