Stream Deck Vertical Desk Stand

I needed a vertical stand for the Stream Deck at my desk, so whipped this up. This holds the stream deck at 55 degrees, and gives a nice cavity for storing excess cable.Assembly instructions: Use a spudger or flathead screwdriver to carefully pry the faceplate off the Stream Deck. After removal, you can remove the electronics from the body.Carefully cut the the body of the Stream Deck to allow for removal of the usb cable.Feed the usb cable through the hole in the vertical stand.Fit the strain relief into the slot in the strain relief insert.Push the insert into the hole in the main body.Coil up any excess cable into the cavity in the body (this would also be the time to add weights if you so wish).Using the pegs as registration points, fit the Stream Deck into the cavity, with the top of the device towards the left side.Fit the faceplate into the groove in the stand (you may have to shave the edges ever so slightly, but if you take small increments, you should get a nice, tight press