Thingiverse
Strong Greg's Extruder
von Nutz95
5
Downloads
3
Likes
0
Makes
Extruder based on http://www.thingiverse.com/thing:456025
I have added the hole for J-Head and some screw holes to keep JHeads fixed.
This part is for 3mm filaments
You will need to generate support to print this part.
I liked this part because it's strong between the 2 ball bearings. I have already broken 2 extruders exactly on this specific spot and this design was the one i was looking for except that i needed the hole for the hot end.
I have added the hole for J-Head and some screw holes to keep JHeads fixed.
This part is for 3mm filaments
You will need to generate support to print this part.
I liked this part because it's strong between the 2 ball bearings. I have already broken 2 extruders exactly on this specific spot and this design was the one i was looking for except that i needed the hole for the hot end.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
