Strong Locking Cable Clip | Desk Cable Holder

Why Make Yet Another Cable Clip? I tried the very popular Klamma cable clip, and while the design is really clever, I felt it was too flimsy, especially if not mounted to a flat surface, it would open on its own quite easily. So I made this one, which should not have the same problem. How to Print Material: PLA or PETG both work fine. Layers: Prints fine up to 0.3mm layer height. Perimeters: 2 is enough. Infill: 15% is enough. Supports: not needed. Just make sure you have good bed adhesion and it will print fine. 4 Mounting Options There are four versions of the clip, pick one that works for how you want to mount it. Double-sided tape Recommended option for using as a desk-side cable holder or for semi-temporary installations There is a cutout at the back sized to take a bit of this 30 mm reusable double-sided tape. The depth of the cutout is a bit less than the thickness of the tape, allowing it to stick to stuff but minimizing wobble that you would otherwise get with such a thick tap