Strong Wall Hanger

You can choose the infill as you like. Obviously the higher the better. I used 100%.

The holes have 4.5mm diameter. The total length, including base, is 12cm. Quite a few different screws should fit there. If you are gonna use it on drywall, you really should use anchors.

Keep in mind it is a pretty long piece. I would not recommend using it as a coat hanger or something, because hooks that are closer to the base can hold significantly more weight and not cause as much stress on the wall. This could be useful for like umbrellas or something, I'm not quite sure.

I had to make this for a completely unrelated personal project, but figured I would post it just in case someone needs something like this lol.

Oh, I would also print it standing up, because that way there are very few support to worry about, and the screw holes will come out way nicer.