Stronger Hydrometer Drybox

So I ran the ‘ALL Drybox’s For AMS (Fixed Hydrometer) Remixed by Pedro748 on my new X1C in Bambu Matte PLA. I don't know what the implied ‘unfixed’ version's issues were, but when I was putting the correct model hydrometer into the center Drybox, it snapped the print on both sides as shown in the picture. The perforated walls of the model at the narrow points are separated into an external wall and the circular wall of the hydrometer socket, with a space too narrow for any desiccant beads to fit in. So I simply merged the exterior slats with the socket side slats on both sides and then solidified a narrow band at the weakest point. I also shaved a thousandth of an inch off the internal wall of the socket, at a much higher resolution to eliminate some faceting that might have been the reason the hydrometer had a tight fit. Other than this one issue, the entire set by Pedro748 is perfect. So if you had the hydrometer box crack like this, this one will not, but is otherwise identi