stubby holder with ice wall

This desing is made for standart size beers (61mm diameter) to keep them cool. Nice barrel looking stubby holder. after 3D print add water to the middle part. screw the top and put in the freezer. once the water in between the wall get frozen is design with a single inner wall to cool (keep cool) your drink while the other wall is doble with low infill to provide isolation from the hand. Recomended to use some pluming tape on the base of the lead or add a o-ring to stop the water from leak once defrosted. 0.2mm layer high%10 standart infillNo supportaround 5 hours to print in P1S.