Thingiverse
Student Driver Magnet
por CampDaddy
11
Descargas
11
Likes
1
Makes
Hadn't found one on here yet, so did one up quick. Student Driver magnet bumper "sticker". I use 4-10x2mm magnets snapped and glued into the back, then covered with a 1x1" piece of gaffer tape to avoid scratches to the surface.
This is as close as I could get to the school bus font, set a pause at height in Cura post processing to change the filament color about 3 layers down from the top.
This is as close as I could get to the school bus font, set a pause at height in Cura post processing to change the filament color about 3 layers down from the top.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
