MakerWorld
Other House Models
Zum Modell
Sturdy S Hook
13
Downloads
6
Likes
7
Makes
I was absolutely fed up with my old S-hooks constantly slipping off the clothing rod every time I grabbed something hanging on them, like my jacket. It was one of those small everyday annoyances that somehow manages to happen at the worst moment.So I designed my own solution: a 3D-printed hook that doesn’t fall off the rod. Instead of just hanging loosely like an S-hook, this one clips into place and stays put when you pull a jacket, bag, or anything else off it.My clothing rod is about 35 mm in diameter, and this hook is designed to fit that size. If your rod is different, you can most likely scale the model to match your setup.Printed in PETG
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
