Thingiverse
Stylish LED Light for Geeetech i3
di hopalbunda
0
Download
0
Likes
0
Makes
LED light for quick check up of your print.
Batteries may not seem as the best option, but I have been using them for half year so far and they still work good with no signs of discharging!
LED Strip is hanged so it gets cooled by air.
Printed parts:
- 1x main.stl
- 18x strip_holder_side.stl
- 10x strip_holder_top.stl
Additional requirements:
- 1x M3-10 screw or longer
- M3 tap
- 2x 9V batteries (can be only one, 2 for more durability)
- 2x 9V battery connector
- 1x power switch (7,5 mm x 13 mm body, through-hole diameter D < 6,5 mm)
- 70 cm 20 W·m^-1 120° 12V LED strip
- 15cm piece of two-lane wire
- soldering equipment
Optional:
- some cable connector
Batteries may not seem as the best option, but I have been using them for half year so far and they still work good with no signs of discharging!
LED Strip is hanged so it gets cooled by air.
Printed parts:
- 1x main.stl
- 18x strip_holder_side.stl
- 10x strip_holder_top.stl
Additional requirements:
- 1x M3-10 screw or longer
- M3 tap
- 2x 9V batteries (can be only one, 2 for more durability)
- 2x 9V battery connector
- 1x power switch (7,5 mm x 13 mm body, through-hole diameter D < 6,5 mm)
- 70 cm 20 W·m^-1 120° 12V LED strip
- 15cm piece of two-lane wire
- soldering equipment
Optional:
- some cable connector
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
