Thingiverse
Robotics
Vai al Modello
Stylosaurus Writing Robot
9
Download
9
Likes
0
Makes
End Caps for Open V-Slot 2020 with Open Hardware logo.
This is a remix from https://www.thingiverse.com/thing:398515, redesigned to use more commonly available parts off the shelf from Amazon.
If you print your own linear bearings and use the cheaper A4988 stepper drivers, this robot can be built for less than $100!
The build itself is quite easily done, everything should work out of the box saved for three caveats:
1. If you use the silent motor drivers like I did, make sure you bend out the two pins facing down near the capacitor on the motor shield or they might short.
2. The servo should be plugged into A6 slot on the motor driver board. A wire then has to be soldered between the Arduino's D11 and A6 pins to enable the servo.
3. To use the grbl coreXY-servo firmware with an Arduino Nano, you have to upload the Uno bootloader to it first or the firmware won't fit!
...But that's it!
Uses Inkscape 0.91 + J Tech Photonics Laser Tool V_10, the Universal Gcode
This is a remix from https://www.thingiverse.com/thing:398515, redesigned to use more commonly available parts off the shelf from Amazon.
If you print your own linear bearings and use the cheaper A4988 stepper drivers, this robot can be built for less than $100!
The build itself is quite easily done, everything should work out of the box saved for three caveats:
1. If you use the silent motor drivers like I did, make sure you bend out the two pins facing down near the capacitor on the motor shield or they might short.
2. The servo should be plugged into A6 slot on the motor driver board. A wire then has to be soldered between the Arduino's D11 and A6 pins to enable the servo.
3. To use the grbl coreXY-servo firmware with an Arduino Nano, you have to upload the Uno bootloader to it first or the firmware won't fit!
...But that's it!
Uses Inkscape 0.91 + J Tech Photonics Laser Tool V_10, the Universal Gcode
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
