Slicer Discord
Subaru FA20 & EJ Oil Funnel – 3D-Druckmodell von MakerWorld MakerWorld
Vehicles

Subaru FA20 & EJ Oil Funnel

874 Downloads
235 Likes
578 Makes
Zum Modell
This is a screw on oil funnel for the FA20 engine in the 2015+ Subaru WRX. It also works on a 1997 JDM ej20k so this very likely works on any Subaru engine out there. Just take the cap off and this fits into the oil filler neck. This funnel is extra thick and should last a long time and be tough to break. Maybe the straw helps maybe it doesn't but it cannot hurt having a dedicated place for air to escape. I have provided 2 models here. The first one has a single straw to allow air to flow up and back out of the engine to aid in filling oil. This was the whole idea behind making this funnel in the first place. The second model takes this principal and turns it up to 11(okay, technically 6) because if one air pipe is good then 5 more has to be better, right? Totally.
Kategorie
Vehicles
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

NotForEveryone veröffentlicht auch auf

4 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen