Thingiverse
Subaru key holder
von Fundowicz
4
Downloads
1
Likes
0
Makes
I created this model and printed it using a monoprice iiip 3d printer.
fits the command strip for picture frames that holds 16 lbs, but that is assuming you follow the directions and use 4 strips rather than 1 like I am.
strips:
https://www.amazon.com/Command-Picture-Hanging-12-Strips-17206-12ES/dp/B00LOQMCDM/ref=zg_bs_511352_1?_encoding=UTF8&psc=1&refRID=A0Z8MG6W4BTXEFH49782
fits my Subaru outback keys nicely.
painted poorly because i use a soldering gun to flatten out the areas where the supports where so they are super smooth, but happen to discolor the plastic.
i can make this for other keys if there is enough demand.
fits the command strip for picture frames that holds 16 lbs, but that is assuming you follow the directions and use 4 strips rather than 1 like I am.
strips:
https://www.amazon.com/Command-Picture-Hanging-12-Strips-17206-12ES/dp/B00LOQMCDM/ref=zg_bs_511352_1?_encoding=UTF8&psc=1&refRID=A0Z8MG6W4BTXEFH49782
fits my Subaru outback keys nicely.
painted poorly because i use a soldering gun to flatten out the areas where the supports where so they are super smooth, but happen to discolor the plastic.
i can make this for other keys if there is enough demand.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
