Slicer Discord
Subwoofer enclosure – 3D printable model from MakerWorld MakerWorld
Music

Subwoofer enclosure

716 Downloads
300 Likes
39 Makes
Go to Model
This is an enclosure for the Tang Band W3-1876S Sub woofer that will bring a serious amount of low end bass to your listening experience.With the correct DSP or cross-over you can enhance your listening experience without sacrificing space.The enclosure dimensions are as follows:240mm x 240mm x 121mm heigh. Optional extra:I include in this file the complete sub enclosure and also a amp box which is designed specifically for the DollaTek XH-M180 50Wx4 TDA7850 amplifier. This amp box also accommodates the ADAU1401/ADAU1701 DSP board too for audio correction. If like me you are looking for a small form factor sub woofer to bring an extra dimension to your audio listening experience then look no further. Tang Band have gained a reputation for seriously good speaker drivers and the Tang Band W3-1876S Sub woofer is no exception. Check out you tube if you don't believe me!
Category
Music
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection