Thingiverse
succulent pot
door nmavor
38
Downloads
38
Likes
0
Makes
wall its pot
still, work in progress, but you can install lights if you like you can put it on table/shelf or on the wall
due to the size, you will need cr10 or downsize it for the 200 mm size printers
for the lights use the low end led strip and connect to power
you will need support (I'm using tree support ), but if you get good colling you can see if you can skip support
still, work in progress, but you can install lights if you like you can put it on table/shelf or on the wall
due to the size, you will need cr10 or downsize it for the 200 mm size printers
for the lights use the low end led strip and connect to power
you will need support (I'm using tree support ), but if you get good colling you can see if you can skip support
nmavor publiceert ook op
26 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
