Sugar Rocket

This is a multi piece 3d printable rocket for use with DIY rocket motors made with 5 inch long, 3/4 inch schedule 40 PVC. You can find multiple youtube videos on DIY sugar rocket motors. I based my dimensions off TKOR's video on how to make sugar rockets.

Assembly of this rocket is fairly straight forward. The longer piece with one end mostly closed off is the bottom. you can slide a rocket motor into the larger end and it will stop against the smaller end's "bulkhead". The small hole is to allow a parachute ejection charge to pass into the smaller section of tube that must be glued in place. (sorry i dont know how to to do alignment tabs in cad yet.) The nose cone should fit over the end of the tube just slightly and you should be able to use a screw to attach a parachute line. or if you dont use a chute you can glue this in place. the fins you will need 3 or 4 of depending on the look you are going for. (Again I dont know how to do slots in cad yet) attach the fins to the engine