SulcoWrap roll adapters

These are adapter ends for a SulcoWrap plastic wrap dispenser. I purchased a roll of wrap for my SulcoWrap machine, however the cardboard roll was destroyed and would not roll smoothly in the dispenser. I cut the ends of the cardboard roll off flush with the plastic wrap, and created / installed these ends so it would fit into the machine.

Printed with PLA at 100% and no supports. They were designed with conical centers so there are no need for supports and there is additional clearance for the stub axles. Flip these upside down (so the large end is facing down) and print away. They are a snug fit into the rolls, so a bit of persuasion is needed - if its too much, you can decrease the insert size down from 39mm to 38mm. Cheers