Thingiverse
Sun shade for rifle scope
door lentchr
29
Downloads
22
Likes
0
Makes
Sun shade for 50mm Scope. 57mm scope O.D. 66mm overall O.D. No mounting hardware needed, should be close to interference fit.
The relief cut is for my CZ452, but i have included the non-relief version to just slip on.
EDIT: I made a 30mm version. but i didnt have a 30mm scope to measure the tube diameter. the internal diameter is set at 30.75mm. in order to find the x and y (printed standing up) scaling factor (i wouldnt change the Z scale) find the diameter of you rifle tube and divide by 30.75 and move the decimal 2 places to the right.
Ex: 30mm exactly tube diameter, 30/30.75 ~ .9756, x100= 97.56% scaling factor
Ex2: if you want to use the 50mm tube on the same scope (30mm) the math would look like this 30/57= .5263x100= 52.63%
The relief cut is for my CZ452, but i have included the non-relief version to just slip on.
EDIT: I made a 30mm version. but i didnt have a 30mm scope to measure the tube diameter. the internal diameter is set at 30.75mm. in order to find the x and y (printed standing up) scaling factor (i wouldnt change the Z scale) find the diameter of you rifle tube and divide by 30.75 and move the decimal 2 places to the right.
Ex: 30mm exactly tube diameter, 30/30.75 ~ .9756, x100= 97.56% scaling factor
Ex2: if you want to use the 50mm tube on the same scope (30mm) the math would look like this 30/57= .5263x100= 52.63%
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
