Sunbu AMS Lite Loader Stand - A1 Mini Version

A loader stand for Mr. X3D's great Sunbu AMS Lite/ Sunlu S4 filadryer combo, found here: https://makerworld.com/en/models/155592#profileId-170306 This is printable on the A1 Mini by popular request, and requires some assembly. If you have an A1/P1/X1 sized bed, see the original model here that prints as one piece. https://makerworld.com/en/models/587460#profileId-508654 This stand locks into the center divider of the Sunlu S4, and provides a secure slot to hold the heavy Sunbu AMS vertically while loading or maintenance is performed. The Sunbu AMS is difficult to load by itself because it can't really be put down, especially with PTFE tubes and power connected. This stand is flat bottomed and will also work on any flat surface. This version prints without supports! NOTE: Orient the heavy side of the Sunbu AMS, usually the one with 3 or 4 spools on it facing the longer legs of the stand so it does not tip over(see pic). Make sure the stand is dropped into the center divider and