Thingiverse
Sundvik Pacifier Bin
por HazyOmega
20
Descargas
14
Likes
0
Makes
We were tired of always searching for pacifier in the dark so I made a bin for pacifier (or whatever you want to put in) which clip on the side of the Sundvik crib.
The bin is in two part to allow for no support but a small assembly. I used 1.75mm (15-20mm length) filament to assemble with epoxy.
I printed mine with PETG with brim. I didn't tried without brim but I had similar design where the thin walled leg lift off the bed without brim.
Highly recommend using PETG for the increase flexibility. PLA may break (haven't tried).
Print with the bin side on the bed.
The bin is in two part to allow for no support but a small assembly. I used 1.75mm (15-20mm length) filament to assemble with epoxy.
I printed mine with PETG with brim. I didn't tried without brim but I had similar design where the thin walled leg lift off the bed without brim.
Highly recommend using PETG for the increase flexibility. PLA may break (haven't tried).
Print with the bin side on the bed.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
