Thingiverse
SUNLU dryer filament guide
von mstoica84
105
Downloads
54
Likes
0
Makes
When using SUNLU drybox on top of IKEA Lack enclosure, to make the filament traction smooth I created a filament guide adapter to be used with the lower hole on the case.
This was inspired from https://www.thingiverse.com/thing:4833453 but created from scratch, in order to make the filament hole angle higher.
To make it even smoother I glued textile cable sleeve inside the guide.
I printed it with 0.25mm nozzle and with 0.10mm detail but it should work 0.4 nozzle as well.
This was inspired from https://www.thingiverse.com/thing:4833453 but created from scratch, in order to make the filament hole angle higher.
To make it even smoother I glued textile cable sleeve inside the guide.
I printed it with 0.25mm nozzle and with 0.10mm detail but it should work 0.4 nozzle as well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
