SUNLU E2 DESICCANT DRYING ECO SYSTEM

This is the system I use to dry my desiccant in Filament drying box Sunlu e2.Fine mesh inlay for anealing tray4x clips to hold the mesh down and prevent warping of the meshfunnel to collect dryed desiccantTechnicals:USE HIGH TEMP MATERIAL THAT WILL BE ABLE TO WITHSTAND THE TEMPS THAT YOU WILL DRY YOUR DESICCANT AT.In my case desiccant tray and clips are made of carbon reinforced nylon (Fibertron PA612 CF-fast to print with minimal warping and will withstand the maximum drying temp of the SUNLU E2(110 degrees celsius)Anealing tray with mesh and clamps can hold roughly 700gr of desicannt (I recomend putting no more then 500g per drying since it will be more efective and easier to collect after drying)NOTE: If you're planning to dry at 110 degrees (I do) I recomend increasing the temp gradually since fast heating of the filament drier can couse small explosions of saturated with humidity desiccant balls and then they turn into a fine dust that is hard to clean from the dryer (ask me h