Sunlu Fit 2 modify & bottom box

I too, printed out this box & the extra pieces, but found they didn't work properly. So, I modified them to work with very little sanding or touching.
You will want to use the end of a cut & bent paper clip to hold the pivot bar in place. Otherwise, feel free to use the pivot bar add on & clip listed here.

You can (super) glue the attaching bars to the bottom of your 3D printed Sunlu case, or modify them in your print. I left that only grouped so that you can. If the files become a bother, I'll upload them apart so you can modify them as you like. I print them on my huge Anycubic Kobra Max, so there is ample room.

I have this together, as the additional pictures will show. Everything works fine. The box could stand to use some weight, if you want it open. I, myself close it after getting a clear strip out, from it.

You can use skirts & rafts as your printer or you, desire. I just used a skirt, because I like to have a little extra filament come out to be sure it's clean & ready.

Go