MakerWorld
3D Printer Accessories
Ver Modelo
Sunlu Lid Lifter Handle
72
Descargas
13
Likes
46
Makes
I have the Sunlu four (4) spool filament dryer, “FilaDryer S4”. It's a nice dryer, but trying to open the lid is a real paint for my fat fingers. The lid opening handle is a short stubby thing with barely any area to grip when lifting. So as you slide it unlock, it slips and falls as you lift. I designed this handle to help with that. It snaps into place without glue and can be removed if necessary - This is based off the tolerances of my P1S printer. You may need to apply glue if your tolerances vary. Two lift handles are a 26minute print, using about 10g of filament on my P1S. The filament I used is “E l e goo” PLA + Neon Green.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
