Sunlu S2 Dryer Holder for Multiboard

This is a remix of the Sunlu filament dryer holder by @Ibot_11 (using the “all features” CAD file), adapted for use on a multiboard. The 3mf has 2 plates with different settings, one for PLA and one for ASA. This is a bulky item and can warp in any material, so make sure you know how to minimize these issues. You may still have layer delamination, warping and/or bed adhesion issues, I've done my best with the settings. My ASA model still had a little peeling, warping and layer shifting, but it was minor. During the print, I kept trying to maintain a consistent chamber temp (around 55°C worked best), but the fluctuations caused some waviness in the surface finish. When the print finished, I left it alone for an hour and the the brim still held (using Bambu's liquid glue), but the plate had pulled up off the bed a little in the corners. The layer delamination was minor, but I would know it was there, so I did some light sanding to even out the surface finish, then clamped the par