Thingiverse
SUNLU S2 Filament Drier Mount!
5
Download
2
Likes
0
Makes
Why not dry while you're printing?! A mount for the SUNLU Filament Drier to attach on the top of your Ender3 or Ender3V2.
the Monting base prints flat on the bed and has s living hinge. This helps to captivate the Sunlu Drier to keep it held in place better.
Disclaimer, it's best not to dry filament while your printing as the tension may pull the warm filament and make it thinner, then your extruder can't grab it. If you do, stay below 60C for PLA and 80C for ABS to be safe.
Push pin should be printed on it's side!
1. Mount base on printer with bolts
2. Install Sunlu Drier
3. Fold up hinge
4. Install push pins
5. Install Support Bracket
6. Install https://www.thingiverse.com/thing:5401837 or another filament guide to point your filament in the right direction.
7. Plug in SunluS2
8. Start printing!
the Monting base prints flat on the bed and has s living hinge. This helps to captivate the Sunlu Drier to keep it held in place better.
Disclaimer, it's best not to dry filament while your printing as the tension may pull the warm filament and make it thinner, then your extruder can't grab it. If you do, stay below 60C for PLA and 80C for ABS to be safe.
Push pin should be printed on it's side!
1. Mount base on printer with bolts
2. Install Sunlu Drier
3. Fold up hinge
4. Install push pins
5. Install Support Bracket
6. Install https://www.thingiverse.com/thing:5401837 or another filament guide to point your filament in the right direction.
7. Plug in SunluS2
8. Start printing!
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
