Thingiverse
Sunlu S2 filament guide
door wondah
30
Downloads
23
Likes
1
Makes
Made a filament guide for the Sunlu S2 because the original is crap.
This one works fine for me printing directly out of the dryer.
15cm tube used and the standard bigger coupler from a ender 3v2.
You can screw the bigger coupler in the hole.(9.7mm)
Used double sided tape to mount on the dryer.
This one works fine for me printing directly out of the dryer.
15cm tube used and the standard bigger coupler from a ender 3v2.
You can screw the bigger coupler in the hole.(9.7mm)
Used double sided tape to mount on the dryer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!