Thingiverse
Sunlu S2 PTFE Spacer
por Chinji
11
Descargas
9
Likes
0
Makes
A Spacer for the Sunlu S2 filament dryer with PC4-M10 PTFE compatibility.
Allows for moisture exhaust and PTFE tube connection. The part is reversible for smooth upward/ downward feed.
Other versions had messy topology, walls too thin for printing or other artifacts, so I created this one from scratch.
Print with tree supports and a brim of 3mm for bed adhesion.
For the M10 thread, I recommend to re-tap it using a M10 tap.
Push the PTFE tube completely through the spacer to prevent the filament from dragging on the part.
Allows for moisture exhaust and PTFE tube connection. The part is reversible for smooth upward/ downward feed.
Other versions had messy topology, walls too thin for printing or other artifacts, so I created this one from scratch.
Print with tree supports and a brim of 3mm for bed adhesion.
For the M10 thread, I recommend to re-tap it using a M10 tap.
Push the PTFE tube completely through the spacer to prevent the filament from dragging on the part.
Chinji también publica en
4 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
