Sunlu S2 Spool and Holder (version 2)

### PRINT REQUIREMENTS
_ _
**Filament Quantity:**112.88g (3 wall loops, 10% infill). If you already have the spool roller-and-axel from [Version 1](https://www.thingiverse.com/thing:7170530), you only need to print the A-shaped supports, which are 35.94g.

**Printer Bed Support:** No concerns.

**Supports:** Yes, on the axle pin. See screenshots for demonstration of the recommended concentric-circle pattern and orientation of paint-on organic supports.
_ _
_ _
### PURPOSE
_ _
This is a spool holder and roller set which is designed to be easy to assemble and use. It keeps the filament spool from falling off the roller while slotting it into the dryer, and is designed to spin smoothly even if the dryer is tilted at an angle.

It clips into place via the metal rollers on the bottom of the dryer, and remains firmly attached even when tilted at an angle. Requires no screws. See final photos for demonstration, as I hold the dryer up at an angle and the filament roll remains in place.
_ _