Sunvisor Clip Mazda 121

The sun visor on my jellybean (98' mazda 121) broke so I designed a quick replacement, it fits quite firm but not too much so, if it's a little too tight for your liking you can heat it up with a heat gun and bend the hook up slightly, or just remix it. Hopefully this helps someone, may also fit other mazdas (or other cars).

I printed it in PLA which will hopfully not warp too much during summer, though I'm in Australia and the car is in direct sun (usually 40+ degrees in summer) and we're headed into summer so time will tell. If you're curious if PLA will hold up just leave a comment and I'll reply with how it went.

As I always do I included the step file and fusion file.