Thingiverse
Super Bang Dart
door A1ex101
15
Downloads
11
Likes
0
Makes
The 'Super Bang Dart' is a throwing dart designed to make a large POP! when it lands on a hard surface.
*****ASSEMBLY:*****
1. Cut the base and sharp end off of your nail with pliers or bolt cutters (size shown above)
2. Slide the tail onto the nail and glue
3. Slide on a weight or nut with an offset of about 4-5 mm from the tip, then glue
(I found that two nuts =~ .10 oz works best)
4. Load super bang cap onto tip and throw in a safe direction
*****PLEASE DON'T THROW AT OR NEAR ANY PERSON OR ANIMAL*****
*****ASSEMBLY:*****
1. Cut the base and sharp end off of your nail with pliers or bolt cutters (size shown above)
2. Slide the tail onto the nail and glue
3. Slide on a weight or nut with an offset of about 4-5 mm from the tip, then glue
(I found that two nuts =~ .10 oz works best)
4. Load super bang cap onto tip and throw in a safe direction
*****PLEASE DON'T THROW AT OR NEAR ANY PERSON OR ANIMAL*****
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!