Thingiverse
Super Bee Motor Pods
von Mid7night
24
Downloads
11
Likes
0
Makes
This is a motor mount & pod that I made for my highly modified FT Super Bee, because I wanted a stronger motor mount for my application.
If using on the FT Super Bee, you will need to cut two additional slots in the bottom of the wing for the motor mount tabs to fit into. Otherwise, use at your own discretion!
Motor mount holes are sized for EMAX RS2205, RS2306, and any similar sized motors with 16mm x 19mm hole spacing and M3 screw holes.
If using on the FT Super Bee, you will need to cut two additional slots in the bottom of the wing for the motor mount tabs to fit into. Otherwise, use at your own discretion!
Motor mount holes are sized for EMAX RS2205, RS2306, and any similar sized motors with 16mm x 19mm hole spacing and M3 screw holes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
