MakerWorld
Gadgets
Go to Model
Super Fast Wine Chiller
22
Downloads
19
Likes
8
Makes
Cool down your wine in ⅓ of the time with science!!! This is an adapter that attaches your wine bottle to a normal screwdriver drill bit. I did some testing on how quick it works versus sitting in ice water alone so you don't have to. *Note: The threads may be a little tight the first time. You should use a back and forth turning motion to get them to free up when you get to any tight spots. After you get it though to the end it should be smooth the next time through. Scientific process:-Two wines (one white/one Rose) were sitting at the same room temperature of 69F-Test rig was the same 7" diameter cylinder x 9" tall vase mode TPU print (a little leaky at the bottom but otherwise the perfect vessel for testing.) Inner screen at 3.5" diameter cylinder PLA with gyroid infill and no shells to act as a screen to keep the ice at the sides of the vessel when I pulled the bottle out for temperature checks- Each test 1.5kg of ice added and cold water filled from sink up to the
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!