Thingiverse
Super Knob CR-10 Dial
door beejayf
7
Downloads
5
Likes
2
Makes
This knob has two modes of operation: Speed turn between two fingers or fine tune with one finger on one of the cross pins.
Depending on the printer settings the inner diameter might be on the small side: If it won't snap on the axis of the CR-10 you can use a 6mm drill to spindle out the inner diameter and you should be good to go.
Depending on the printer settings the inner diameter might be on the small side: If it won't snap on the axis of the CR-10 you can use a 6mm drill to spindle out the inner diameter and you should be good to go.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
