MakerWorld
Other Toys & Games
Ver Modelo
Super Mario Fidget Slider Pack
24
Descargas
30
Likes
8
Makes
Uses 9 6x3mm magnets for each face. Use Maker Supply magnets or these from Amazon. Tolerances will vary with different filaments. If the magnets are a loose fit, I suggest gluing them in so they do not slide around inside the base. If the magnets are a tight fit, I suggest using a tool to force them in or scale the base up slightly. Make sure you install the magnets so that each base will attract to each other. Once the magnets are set, the faceplate can be pressed into place. If you do not have a second AMS, but would like to print the flower, place a pause at layer 13 and swap out the black for red filament.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
