Thingiverse
Super Mario PRINTABLE Level 1 (part 2)
von PapaCled
11
Downloads
11
Likes
0
Makes
This has been designed by myself 1:1 scale of Mario Level 1.
So far i have parts 1, 2, 3, 4, 5, 7 and 8 completed. The rest will be following soon so keep an eye out.
Fully printable.
Recommended to print flat on its back, but you could print it as standing up with supports.
Each STL print is 224mm long, 14mm deep. (Each block is 7mm x 7mm).
The idea is to glue each section to the next which should be seamless, the floating blocks could either be suspended with clear perspex, or filament straight off the reel cut and glued should be strong enough to support them.
0.1 res will be needed on this
10% infill
supports depending how you position it
Follow and watch for next sections coming soon
So far i have parts 1, 2, 3, 4, 5, 7 and 8 completed. The rest will be following soon so keep an eye out.
Fully printable.
Recommended to print flat on its back, but you could print it as standing up with supports.
Each STL print is 224mm long, 14mm deep. (Each block is 7mm x 7mm).
The idea is to glue each section to the next which should be seamless, the floating blocks could either be suspended with clear perspex, or filament straight off the reel cut and glued should be strong enough to support them.
0.1 res will be needed on this
10% infill
supports depending how you position it
Follow and watch for next sections coming soon
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
