Thingiverse
Super Mario Question Mark box
by sbarabe
6
Downloads
2
Likes
0
Makes
This a 75mmx75mm Super Mario Question Mark Box. It has a snapping lid. The walls have 1.2mm, so 3x 0.4 nozzle wide.
I have printed it on my Da Vinci Minimaker, and I had a few issues with warping and under extrusion. It is not design related...
Hope you'll have better success with your print !
_____________
Update : it appears that my Cura setting were no good for thin wall, even if I've design this print to fit 0.4 nozzle. I tough I had under extrusion on my first print, but it seems it was a poor link between first and 3rd layer of the walls even if I check 100% infill in CURA. I've printed my second one in XYZprinting slicer and it did print well except some artifacts from the slicer... So beware if you're using CURA, and feel free to share you're setting for thin walls.
I have printed it on my Da Vinci Minimaker, and I had a few issues with warping and under extrusion. It is not design related...
Hope you'll have better success with your print !
_____________
Update : it appears that my Cura setting were no good for thin wall, even if I've design this print to fit 0.4 nozzle. I tough I had under extrusion on my first print, but it seems it was a poor link between first and 3rd layer of the walls even if I check 100% infill in CURA. I've printed my second one in XYZprinting slicer and it did print well except some artifacts from the slicer... So beware if you're using CURA, and feel free to share you're setting for thin walls.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
