Thingiverse
Super Simple Vase Mode Christmas Tree
by ZacSimmo
2
Downloads
21
Likes
0
Makes
A clean, single-wall Christmas tree designed for vase mode printing. The model uses the full Ender 3 Pro bed and prints as one continuous spiral, giving a seamless, smooth finish. Ideal as a quick festive decoration or flexible display piece.
Print Settings
Printer: Creality Ender 3 Pro
Layer Height: 0.16 mm
Print Speed: 20 mm/s
Supports: Yes (for small overhangs)
Infill: None (vase mode disables it)
Raft: No
How-To: Enable Vase Mode in Creality Slicer
Locate “Spiralize Outer Contour” in the Special Modes section at the bottom of your Print Settings list. This is the vase mode setting.
If it isn’t visible, open the Settings toolbar, select “Configure Setting Visibility…”, and enable Spiralize Outer Contour.
For best results:
Increase Line Width to around 0.6 mm if using a 0.4 mm nozzle.
Ensure Print Cooling is enabled.
Raise Printing Temperature by about 5°C above your usual setting for smoother extrusion.
The printer will build the tree in a single continuous spiral, producing
Print Settings
Printer: Creality Ender 3 Pro
Layer Height: 0.16 mm
Print Speed: 20 mm/s
Supports: Yes (for small overhangs)
Infill: None (vase mode disables it)
Raft: No
How-To: Enable Vase Mode in Creality Slicer
Locate “Spiralize Outer Contour” in the Special Modes section at the bottom of your Print Settings list. This is the vase mode setting.
If it isn’t visible, open the Settings toolbar, select “Configure Setting Visibility…”, and enable Spiralize Outer Contour.
For best results:
Increase Line Width to around 0.6 mm if using a 0.4 mm nozzle.
Ensure Print Cooling is enabled.
Raise Printing Temperature by about 5°C above your usual setting for smoother extrusion.
The printer will build the tree in a single continuous spiral, producing
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
