Super-spin Magnetic Fidget

DescriptionThis is my version of a spinner fidget magnetic toy. It is only 45x24x14mm and you can slide it up-down and spin it around. You will need 5 4x2mm magnets, 10 3x2mm magnets and 1 bearing 686zz. Boost MeI would appreciate your boost if you like the model!AssemblyThe spinner is composed of 3 parts: bottom, top and cap. You can mix and match all parts between to combine them and have many different variants. You don't need any supports in any part. Model is optimised to print with 0.1mm layer height. Use 100% infill as the added weight helps the spinning.Bottom: This part needs 5 magnets of 4x2mm and 6 magnets of 3x2mm. Add a little bit of glue (printing is not tight) and make sure all magnets have the same orientation.Up: This part needs 1 magnet of 4x2mm and 4 magnets of 3x2mm. Again, use glue for them and make sure the orientation is opposite to the bottom part so when you face each other they attract. You also need the include the 686zz bearing. Print this part with brim