Thingiverse
Super tight Raspberry Pi case
von Mordin
35
Downloads
18
Likes
0
Makes
Made to be as small as possible, this is the first version that fits perfectly.
I will improve the case if any suggestions are made :) enjoy!
Printed with 0.2 precision, quite high speed (Should probably lower it a bit).
The file names indicates:
HOLE:
These ones has a hole on the back to be able to push the Raspberry out of the case.
ROUNDED
I chamfered the corners a bit for smoother look
(Default sharp corners).
(Update 2017-05-03: Made a bit more spacing between lid & bottom at left side between contacts).
I will improve the case if any suggestions are made :) enjoy!
Printed with 0.2 precision, quite high speed (Should probably lower it a bit).
The file names indicates:
HOLE:
These ones has a hole on the back to be able to push the Raspberry out of the case.
ROUNDED
I chamfered the corners a bit for smoother look
(Default sharp corners).
(Update 2017-05-03: Made a bit more spacing between lid & bottom at left side between contacts).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
