Thingiverse
Superman Iphone 6/6s case
door swoolsten
7
Downloads
3
Likes
0
Makes
Remix of the phone case by Snickerpleez. Replaced the back card holder with a solid back and cutout superman logo. Superman logo is a remix of https://www.thingiverse.com/thing:835828.
The front of the case is unchanged from the original design. Turned out great, it's a very durable case. I've dropped my phone several times and I'm certain this case saved my phone. I'd upload a pic, but my phone is my only camera. I'll try and get one up soon.
Check out the original by Snickerpleez to get an idea of what it will look like: https://www.thingiverse.com/thing:1002726
Phone fit is pretty tight, if I were to do it again I may consider scaling it up a half percent or so.
I printed this in PLA, at .1 resolution and a 1.2mm perimeter.
The front of the case is unchanged from the original design. Turned out great, it's a very durable case. I've dropped my phone several times and I'm certain this case saved my phone. I'd upload a pic, but my phone is my only camera. I'll try and get one up soon.
Check out the original by Snickerpleez to get an idea of what it will look like: https://www.thingiverse.com/thing:1002726
Phone fit is pretty tight, if I were to do it again I may consider scaling it up a half percent or so.
I printed this in PLA, at .1 resolution and a 1.2mm perimeter.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!