Thingiverse
SuperMop spinmop replacement TPU plug
door guysoft
0
Downloads
1
Likes
0
Makes
The spinning mop that I had palug broke, this is a replacement, for 22mm hole, print in TPU.
Note the part measurement is 23mm. I found that with my current printer calibration TPU shrinks more than PLA or ABS. So this was to compensate. There is a FreeCAD file if you want to edit the parameters in the sheet.
Note the part measurement is 23mm. I found that with my current printer calibration TPU shrinks more than PLA or ABS. So this was to compensate. There is a FreeCAD file if you want to edit the parameters in the sheet.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
