Thingiverse
Supernote Stylus Stand
door kitlaan
5
Downloads
3
Likes
0
Makes
A vertical stand for the Ratta Supernote (Standard) Stylus. Gets it off the table so it can be picked up easily and also so it doesn't roll around (not that it rolls much before).
As pictured with 0.1mm layers, but it also printed properly with 0.2mm layers. The tolerances are "just right", so if your printer is over-enthusiastic, you may need to scrape at the inside a little.
As pictured with 0.1mm layers, but it also printed properly with 0.2mm layers. The tolerances are "just right", so if your printer is over-enthusiastic, you may need to scrape at the inside a little.
kitlaan publiceert ook op
49 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
