Thingiverse
Supernova E3 Handlebar Adapter
by funkyluke
2
Downloads
2
Likes
0
Makes
2023 Update:
widened to 12mm and improved geometry on clamp. now uses a M4 screw to close.
Fitment is quite tight, if it is too small to fit your handlebar dremel it out or print at 102~105%
This is a handlebar mount for the standard E3.
It is made for 31.6mm Handlebars and is probably a bit on the tight end - you may need to sand it a bit to fit properly.
Needs a Ruthex or similar M3 threaded insert.
widened to 12mm and improved geometry on clamp. now uses a M4 screw to close.
Fitment is quite tight, if it is too small to fit your handlebar dremel it out or print at 102~105%
This is a handlebar mount for the standard E3.
It is made for 31.6mm Handlebars and is probably a bit on the tight end - you may need to sand it a bit to fit properly.
Needs a Ruthex or similar M3 threaded insert.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
