Thingiverse
SuperNova RC plane
by Itek
2.1k
Downloads
1.8k
Likes
9
Makes
SuperNova inspired by rcFoamFighters SuperNova foam pusher plane.
Wings are 1 layer shells (0.4mm) with 1 layer cross internal structure (0.4mm).
3D files are of the right side of the plane only. You will need to mirror all the parts to make the left side.
See PDFs.
There are only 3D files for half a plane. Youll have to mirror the files to make the other half of the plane. I used Cura slicer to mirror my files when I printed.
Files with names starting with "smaller" is alternative prints for those who got smaller printers (split in 2 at center compared to the larger parts).
Center of gravity: approx 45,5 cm from the tip of the nose.
I got my plane to 1420 grams incl. electronics (4S 1300mAh).
Parts glue toghether using (sandpaper+) superglue.
My setup in the video:
Turnigy 60A speed controller
Turnigy 2836-2350 motor
7x5 propeller? (a bit uncertain)
4S 1300mAh battery
I guess I was using Hextronic D-MG16 (Size: 29 x 11.2 x 29mm)
September 2022:
All the f
Wings are 1 layer shells (0.4mm) with 1 layer cross internal structure (0.4mm).
3D files are of the right side of the plane only. You will need to mirror all the parts to make the left side.
See PDFs.
There are only 3D files for half a plane. Youll have to mirror the files to make the other half of the plane. I used Cura slicer to mirror my files when I printed.
Files with names starting with "smaller" is alternative prints for those who got smaller printers (split in 2 at center compared to the larger parts).
Center of gravity: approx 45,5 cm from the tip of the nose.
I got my plane to 1420 grams incl. electronics (4S 1300mAh).
Parts glue toghether using (sandpaper+) superglue.
My setup in the video:
Turnigy 60A speed controller
Turnigy 2836-2350 motor
7x5 propeller? (a bit uncertain)
4S 1300mAh battery
I guess I was using Hextronic D-MG16 (Size: 29 x 11.2 x 29mm)
September 2022:
All the f
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!