Thingiverse
Support for a custom frame
door gepigom2883
1
Downloads
0
Likes
0
Makes
Support for a custom frame made with 2 glued 3 mm baswood plywood
You need two, one of them mirrowed on Cura or any slicer that you normally use
No supports needed
Made in PLA at 5 % infill on Ender 3
You need two, one of them mirrowed on Cura or any slicer that you normally use
No supports needed
Made in PLA at 5 % infill on Ender 3
gepigom2883 publiceert ook op
38 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
