MakerWorld
Garden
Zum Modell
Support for cactus or small plants
58
Downloads
23
Likes
39
Makes
My cactus was all bent over, but thanks to this support I was able to lift it up again so it can grow straight. Height of the pole: 180mm (20mm of drill). Diameter of the ring: 100mm. A drop of glue is enough to join the two parts. In the photo my support has some printing defects due to the poor adhesion of the piece to the printer plate, but overall it does its job.
Wood & Handcraft veröffentlicht auch auf
70 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
