Thingiverse
support for filament hanger
von Kmskelton
0
Downloads
0
Likes
0
Makes
I remixed my own rod holder. The adhesive wasn't strong enough to keep the rod holders attached to my filament box so I added triangles.
USE:
- print two of these
- cut a length of PVC pipe that is approximately 6mm (1/4") shorter than the width of the box that filament is stored in
- use an adhesive to adhere the spool holder to the walls of the filament box
- thread spools on pvc
- rest pvc on the holder
USE:
- print two of these
- cut a length of PVC pipe that is approximately 6mm (1/4") shorter than the width of the box that filament is stored in
- use an adhesive to adhere the spool holder to the walls of the filament box
- thread spools on pvc
- rest pvc on the holder
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
